| LDP211213: Blinker with 8 outputs and 16 setting time. Impulse1 + Pause1 --- Impulse8 + Pause8 - TryHex |
| The offered code enables: Start on S1: ImpulsX:OutX=ON & PauseX(OutX=OFF) (while S1 is closed) |
| For Arduino boards: NANO -- UNO -- MEGA |
| |
| Electrical and practical notes: |
| Uses 9V/1A external power supply (VIN/GND) on DC plug (or external 5V/1A on 5V/GND pin). |
| For stable working use: R1-R3 = 3,3K - 4,7K |
| Display of the measured value is in the form of one decimal digit. |
| Use specified type of 7 segments display with decimal points only (not clock dots). |
| Each output can also drive other type of loads (instead relay module as show on connections) up to 5V/20mA (small or medium power SSR or similar) |
| Some ideas: |
| When S1 is closed, before apply power supply, code is activated immediately (while S1 is CLOSE). |
| You can program the data using (LED display+PB1+PB2), then its can be remove. Then controll of working is with position of S1 and power supply (according to set values). |
| |
| Download TryHEX codes below, unpack and upload to the proper Arduino board (Use a free net tool for example XLoader) |
| 1. uc ATmega328-16MHz-5V (NANO,UNO...): LDP211213try-m328 - Try version! Time1-Time16 limited settings to 0-10,0sec. |
| 2. uc AtMega2560 (Mega(ATMEGA2560).....): LDP211213try-M2560 - Try version! Time1-Time16 limited settings to 0-10,0sec. |
| |
| Final (no limit) Hex Code: Make a Donation and then send us an Email with next content: LDP211213 (FHC=FinalHexCode) |
| User guide manual: |
| After applying to the power (or reset), the display shows (----) about 3 sec. During that time: |
| DEFAULT reset settings: Press both buttons (PB1+PB2) and when the screen turns off release. Be sure to do it (only once) after uploading the hex code in Arduino! Default values: P10=5 P12=0 |
| PRESET values settings: Press the PB1 button and when the screen turns off release: |
| P10: Display brightness intensity (0-7) |
| P12: no function yet |
| Additional preset values have no function in this project! |
| |
| SETtings (from "oFF" state only (S1=OPEN) - all changes stay memorized): |
| SET values: Press the PB1(+) button (until the display goes off then release). The set values that can be changed on the buttons (PB1/PB2=+/-) is displayed. After 2 seconds of inactivity, the value on the display is stored. |
| tX1 xxx: ImpulseX time (X=1-8 OutX=ON) 0-999,9sec. |
| tX0 xxx: PauseX time (X=1-8 OutX=OFF) 0-999,9sec. |
| Status of outputs (while S1 is closed): |
| OutX=Active for fime tX1 (X=1-8) |
| |
